Diffraction of a pulse by a three-dimensional corner

Three dimensional diffraction of sonic booms by corners of structure

Diffraction of a plane wave by a three-dimensional corner

By the superposition of the conical solution for the diffraction of a plane pulse by a three dimensional corner, the solution for a general incident plane wave is constructed. A numerical program is presented for the computation of the pressure distribution on the surface due to an incident plane wave of any wave form and at any incident angle. Numerical examples are presented to show the pressure signature at several points on the surface due to incident wave with a front shock wave, two shock waves in succession, or a compression wave with same peak pressure. The examples show that when the distance of a point on the surface from the edges or the vertex is comparable to the distance for the front pressure raise to reach the maximum, the peak pressure at that point can be much less than that given by a regular reflection, because the diffracted wave front arrives at that point prior to the arrival of the peak incident wave

Calculated NMR T_2 relaxation due to vortex vibrations in cuprate superconductors

We calculate the rate of transverse relaxation arising from vortex motion in the mixed state of YBa_2Cu_3O_7 with the static field applied along the c axis. The vortex dynamics are described by an overdamped Langevin equation with a harmonic elastic free energy. We find that the variation of the relaxation with temperature, average magnetic field, and local field is consistent with experiments; however, the calculated time dependence is different from what has been measured and the value of the rates calculated is roughly two orders of magnitude slower than what is observed. Combined with the strong experimental evidence pointing to vortex motion as the dominant mechanism for T_2 relaxation, these results call into question a prior conclusion that vortex motion is not significant in T_1 measurements in the vortex state.Comment: 6 pages, 5 figures, to be published in Phys. Rev.

On the Throughput of Channels that Wear Out

This work investigates the fundamental limits of communication over a noisy discrete memoryless channel that wears out, in the sense of signal-dependent catastrophic failure. In particular, we consider a channel that starts as a memoryless binary-input channel and when the number of transmitted ones causes a sufficient amount of damage, the channel ceases to convey signals. Constant composition codes are adopted to obtain an achievability bound and the left-concave right-convex inequality is then refined to obtain a converse bound on the log-volume throughput for channels that wear out. Since infinite blocklength codes will always wear out the channel for any finite threshold of failure and therefore cannot convey information at positive rates, we analyze the performance of finite blocklength codes to determine the maximum expected transmission volume at a given level of average error probability. We show that this maximization problem has a recursive form and can be solved by dynamic programming. Numerical results demonstrate that a sequence of block codes is preferred to a single block code for streaming sources.Comment: 23 pages, 1 table, 11 figures, submitted to IEEE Transactions on Communication

Lensless wide-field fluorescent imaging on a chip using compressive decoding of sparse objects.

We demonstrate the use of a compressive sampling algorithm for on-chip fluorescent imaging of sparse objects over an ultra-large field-of-view (>8 cm(2)) without the need for any lenses or mechanical scanning. In this lensfree imaging technique, fluorescent samples placed on a chip are excited through a prism interface, where the pump light is filtered out by total internal reflection after exciting the entire sample volume. The emitted fluorescent light from the specimen is collected through an on-chip fiber-optic faceplate and is delivered to a wide field-of-view opto-electronic sensor array for lensless recording of fluorescent spots corresponding to the samples. A compressive sampling based optimization algorithm is then used to rapidly reconstruct the sparse distribution of fluorescent sources to achieve approximately 10 microm spatial resolution over the entire active region of the sensor-array, i.e., over an imaging field-of-view of >8 cm(2). Such a wide-field lensless fluorescent imaging platform could especially be significant for high-throughput imaging cytometry, rare cell analysis, as well as for micro-array research

Lensfree on-chip microscopy over a wide field-of-view using pixel super-resolution.

We demonstrate lensfree holographic microscopy on a chip to achieve approximately 0.6 microm spatial resolution corresponding to a numerical aperture of approximately 0.5 over a large field-of-view of approximately 24 mm2. By using partially coherent illumination from a large aperture (approximately 50 microm), we acquire lower resolution lensfree in-line holograms of the objects with unit fringe magnification. For each lensfree hologram, the pixel size at the sensor chip limits the spatial resolution of the reconstructed image. To circumvent this limitation, we implement a sub-pixel shifting based super-resolution algorithm to effectively recover much higher resolution digital holograms of the objects, permitting sub-micron spatial resolution to be achieved across the entire sensor chip active area, which is also equivalent to the imaging field-of-view (24 mm2) due to unit magnification. We demonstrate the success of this pixel super-resolution approach by imaging patterned transparent substrates, blood smear samples, as well as Caenoharbditis Elegans

Urban storage heat flux variability explored using satellite, meteorological and geodata

The storage heat flux (ΔQS) is the net flow of heat stored within a volume that may include the air, trees, buildings and ground. Given the difficulty of measurement of this important and large flux in urban areas, we explore the use of Earth Observation (EO) data. EO surface temperatures are used with ground-based meteorological forcing, urban morphology, land cover and land use information to estimate spatial variations of ΔQS in urban areas using the Element Surface Temperature Method (ESTM). First, we evaluate ESTM for four “simpler” surfaces. These have good agreement with observed values. ESTM coupled to SUEWS (an urban land surface model) is applied to three European cities (Basel, Heraklion, London), allowing EO data to enhance the exploration of the spatial variability in ΔQS. The impervious surfaces (paved and buildings) contribute most to ΔQS. Building wall area seems to explain variation of ΔQS most consistently. As the paved fraction increases up to 0.4, there is a clear increase in ΔQS. With a larger paved fraction, the fraction of buildings and wall area is lower which reduces the high values of ΔQS